Brake frame license light plate third


















For All Cars and Trucks. This is a Billet aluminum license plate frame with license light and 3rd brake light. This is a plastic red jewel license plate fastener reflector flat dome. For All Chevrolet Cars and Trucks. These are license plate fasteners. Specify red, green, blue, purple, clear or amber below Diamond Jewel. An inexpensive extra accessory to go with your car or truck.

This light and bracket is still one of the most popular and still available from a number of sources. The one shown is from The Hot Rod Company. Chrome plated heavy gauge steel license plate volt light with a stainless steel bracket. Fit standard US sized license plates. An alternative from The Hot Rod Company is this round LED light without a bracket that can mount to the plate or a license plate frame. LED license plate light is encased by a polished stainless steel housing.

Clear lens with 6 white LED lights. Easy to hard wire with only two wires to connect. Designed with 8" between mounting bolts. These are an exact duplicate of the original Ford glass lens taillights. Left light has a lens to illuminate license plate. Recent offering from hot rod parts vendors make the lighting of the plate easier as there are many custom license plate frames with lights attached to choose from.

The relocation of the plate on my roadster made it necessary to provide new mounting points and lighting. I bought this combination license plate frame with light from a vendor at the Portland Swap Meet but found it available from: Hot Rod Parts Clearance on eBay. Mounting holes are countersunk for easy mounting.

I chose to install threaded inserts into the rear panel below the decklid. They offer a permanent mounting point and eliminate the need for a ground wire for the license plate light. You simply drill a hole and install the insert using a pair of wrenches and the special installation piece shown here. An alternative to the threaded insert is these nylon inserts that usually fit into square holes on a bumper. They work fine but make a ground wire for the light necessary because they do not create a metal-to-metal contact with the car sheetmetal.

Mounting holes on the license plate frame are counter sunk so I chose stainless flathead bolts with allen-heads and placed rubber washers between the plate and inserts to space it off due to the curvature in the roadster panel. Grommets like these could be used as spacers or cut to adjust the spacing. Lens is held into the bottom of the housing by two screws. Light mounts to the frame with two screws and the power wire exits through a hole in the housing and plate frame.

About this product. About this product Product Identifiers Brand. Show More Show Less. More items related to this product. You may also like. Show Chrome License Plate Lights. Custom Chrome License Plate Lights. Ratings and Reviews. Most relevant reviews See all 14 reviews. Cheap, but effective? Cheap thin aluminum. Doesn't look sturdy I bought this for my 04 gmc sierra, which has a prerunner style rear bumper. Read full review Verified purchase: Yes Condition: New.

Look good The plate light never worked the red button would make the stop light blink every now and then but never worked correctly. The wires to the battery were not attached good either I may have just got a bad one I diden't think it was worth sending back If you buy cheep, you get cheep lesson learned Verified purchase: Yes Condition: New.



0コメント

  • 1000 / 1000